Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RDBMS Synchronization Error with Action Code 123

Hi there. I've been trying to create a .csv file to import into my secure acs 3.3. Most of the file works, except the lines with Action Code 123(ADD_DIAL_ACCESS_FILTER). The line looks like this.

20, 0, User-Name,,123,,"Site-Device,*,*,*",AAA Client/Port,,6/25/2008 9:46,0,,,0

After running the sync, i go into the rdbms report. When it gets to these lines in the csv file, i get the ERROR: Parse Error: Reason - Value out of Range" [SI=20 A=123 UN="User-Name" GN="" AI="" VN="" V1="Site-Device * * *" V2="AAA Client/Port" V3=""]

I've tried messing around with the VI section, but can't seem to get it right.

I have been able to use Action Code 122 for the ADD_NAS_ACCESS_FILTER. I want this user to only be able to access the devices in this section.

Please help.

Thank You,

Andrew S.

  • AAA Identity and NAC
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: RDBMS Synchronization Error with Action Code 123

Hi

V2 should have one of these literal values (without the quotes):

"CLID"

"DNIS"

"CLID/DNIS"

"NAS/PORT"

The value of V1 will should then match to be either a single clid or dnis value or combined clid/dnis or nas/port

eg "1.2.3.4/tty0" or "214-300-123/001800123456"

Although I wrote a lot rdbms sync... I dont think this bit was mine!!!

2 REPLIES
Silver

Re: RDBMS Synchronization Error with Action Code 123

Refer to the following url for more information on this error message.

http://www.cisco.com/en/US/docs/ios/12_2sb/system/messages/sm2sb03.html#wp1014085

Also use the error message decode present in the following url:

http://www.cisco.com/pcgi-bin/Support/Errordecoder/index.cgi

Silver

Re: RDBMS Synchronization Error with Action Code 123

Hi

V2 should have one of these literal values (without the quotes):

"CLID"

"DNIS"

"CLID/DNIS"

"NAS/PORT"

The value of V1 will should then match to be either a single clid or dnis value or combined clid/dnis or nas/port

eg "1.2.3.4/tty0" or "214-300-123/001800123456"

Although I wrote a lot rdbms sync... I dont think this bit was mine!!!

242
Views
5
Helpful
2
Replies