Receive error message %TAC+: no address for get_server after my switch is rebooted
I'm trying get TACACS working on a Catalyst 3650 with IOS Version 15.0(1)SE2, RELEASE SOFTWARE (fc3). I believe my AAA model is defined correctly since it doesn't work properly until the switch is rebooted then I have to remove the TACACS server group and add it back in in order to get it to work. I can still logon via SSH but authorization fails when I try enter any commands under the privileged exec mode which tells me the authentication piece is still working but the authorization step fails. I confirmed it in ACS as well. Below is my config hope someone has an idea on how to resolve this issue thanks for the help.
aaa group server tacacs+ X server name auth1 server name auth2
aaa authentication login default local aaa authentication login TacLogin group X local aaa authorization console aaa authorization config-commands aaa authorization exec default local aaa authorization exec TacAuth group X local aaa authorization commands 0 default local aaa authorization commands 0 TacCommands0 group X local aaa authorization commands 1 default local aaa authorization commands 1 TacCommands1 group X local aaa authorization commands 15 default local aaa authorization commands 15 TacCommands15 group X local aaa accounting exec default start-stop group X aaa accounting commands 15 default start-stop group X
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...