I'm trying to configure redundant acs servers in my lab. What interface commands are needed to make this happen. I have both the servers in globally on the switch and I when I block the connection that it authenticates to first and tell the port to re-authenticate the switch tries the next server but the port is marked as unauthorized and the host fails authentication. I can authenticate to either server one by one but not in a failover situation. below i have my port config. I believe im missing something in my port config. Thanks for any help.
You would define multiple RADIUS servers in the switch configuration, then point the authentication and authorization methods to them, the switch should try them in the order in which they appear, rolling over to the next one if the first one does not reply within the timeout period.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...