Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Remote agent and multiple ACS

Can you setup a remote agent to be used by more then one ACS. I have two ACS servers V4.1 and I would like to have two remote agents and have either ACS access both remote agents.

During the remote agent install it request one IP of a ACS.

thanks

Steve

2 REPLIES
New Member

Re: Remote agent and multiple ACS

Yes, this should be possible. After initial setup you can add additional ACS servers in the CSAgent.ini file.

Add the additional ACS servers to the PermitedClients option

More details can be found at http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193a9b.html#wp838093

Joost

Re: Remote agent and multiple ACS

@JOOST HAGE  Could you please show example of how to configure more than ACS to a remote agent. I tried to add ConfigProviderHost in CSAgent.ini as follows :

ConfigProviderHost=192.168.1.x ,192.168.2.x

But it's not work. The remote agent didn't got any log.


Please advise.


Thank you.

230
Views
0
Helpful
2
Replies
CreatePlease to create content