Is it possible to restrict a user account in ACS to be only allowed from a specified source address?
We use token cards for normal admin access but we have an automated script that backs up the configs and therefore uses a static account. We have implemented shell command authorization to limit potential exposure of this account becoming know but would also like to restrict this account to a specific source ip address to secure it further.
I tried the other guys response. It does not work for me. The advanced field does not populate with the ip's or groups. I created a network access filter as well and tried to apply but that did not work either. Anyone else have some suggestions. Hopefully in the 5 years since this question was posed someone figured it out
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...