Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SDM through aaa authentication using rsa secureid

Hi,

I'm currently testing with Cisco's SDM interface combined with Cisco ACS authentication using rsa secureid. Tests without the rsa securid, just a username/pass combination all works well, however combining the securid, sdm keeps popping back up. CLI access using acs with the secureid works fine.

Attached: debug output from a sdm https securid session

http authentication keeps getting a failure

Any suggestions?

2 REPLIES
Bronze

Re: SDM through aaa authentication using rsa secureid

http authentication will need a user at privilege level 15. This is also seen in your output

"HTTP: Authentication failed for level 15"

Give the user the privilege level of 15 and see if it works.

New Member

Re: SDM through aaa authentication using rsa secureid

Hi vkapoor5,

I've already done that. When i'm not using the RSA secureid just plain login / passw everything works fine. Both methods, using priv15 or passing a cli-view work except when i'm using a secureid.

I think it has something to do with caching of the token en passing it multiple times in the SDM login procedure although this obviously works only one time.

249
Views
0
Helpful
2
Replies