cisco-avpair="tunnel-private-group-ID(#81)=2" (2 is my vlan id)
but when I insert these into radius DB (I have also tryed with text file config...) I can see from Radius debugs that only the first one (cisco-avpair="tunnel-type(#64)=VLAN(13)" is passed in the access-accept packet.
Here are some outputs:
Sending Access-Challenge of id 80 to 126.96.36.199:1812
Re: Send vlan via Radius with 802.1x Authentication
I am not an expert in this area either. In fact I am trying to accomplish the same exact thing that you are doing except that I don't have the freeradius expertise that you seem to have. Any insight on freeradius you can provide such as configs and files would be greatly appreciated.
What version of code do you have on the 2950, I would try to upgrade that to a more recent release.
Also, where did you find out about the variables that should be passed to the Cisco device?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...