Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting privileges in Cisco Secure ACS Version 5.1.0.44

I am setting privileges in Cisco Secure ACS Version 5.1.0.44.
In the command sets from the ACS server, I denied few commands as can be seen in the attached screenshot and selected 'Permit any command that is not in the table below'.
I am unable to see some commands like "Show running-configuration" from the router I was testing. What changes should I do to see all the commands other than the denied commands. Your help will be rated. Thank you.
1 REPLY
New Member

Re: Setting privileges in Cisco Secure ACS Version 5.1.0.44

Hi,

The ACS is able to handle permit or deny commands.

I created a configuration example that will help you to understand command shell.(see attach doc)

Instead of using show running-config please use show config.

also make sure that all the users are using privilege 15.

Regards,

775
Views
0
Helpful
1
Replies