Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Setup ACS4.0 appliance as TACACS+ Server

This may seem like a daft question but I cannot see, nor find, how to setup a ACS server as a TACACS+ server. The interface configuration screen only shows RADIUS options. Can someone point me in the right direction please??

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Setup ACS4.0 appliance as TACACS+ Server

Add a TACACS+ device into Network Config.

... then all will be revealed!

Darran

3 REPLIES
Silver

Re: Setup ACS4.0 appliance as TACACS+ Server

If you're looking for TACACS+ options under users or groups, check the following to enable some of the options under groups.

Interface Config->TACACS+

Also, check the following to enable Per-user TACACS options.

Interface Config->Advanced Options

If you're looking for something else and I'm not understanding you properly, please let me know more info of what you are looking for, such as if you're looking for router configs, etc. If you?re looking for where to enable the TACACS+ service, it is on by default (and I don't know of a way to kill it for that matter).

-Eric

[EDIT]

Well, after reading more carefully, it sounds like you don't see the TACACS option in Interface Config. If that is the case, what exactly DO you see there? I have the following (not an appliance, but should be similar).

User data config, TACACS+, RADIUS(IETF), RADIUS(Cisco Airespace), Advanced Options

Sorry for mis-reading.

-Eric

New Member

Re: Setup ACS4.0 appliance as TACACS+ Server

Thanks for the reply Eric.

You are correct I do not see TACACS+ under interface config. All I see is:

User data config, RADIUS (Cisco IOS / PIX6.0), RADIUS (Microsoft), RADIUS (Ascend), RADIUS (IETF), Advanced Options.

Thanks,

Robin.

Silver

Re: Setup ACS4.0 appliance as TACACS+ Server

Add a TACACS+ device into Network Config.

... then all will be revealed!

Darran

484
Views
0
Helpful
3
Replies
CreatePlease to create content