Did anyone have a hard time integrating ISE 1.2 with SNMP server for polling system parameters? I'm trying to add ISE 1.2.1 to solarwinds SNMP server but when adding the required parameters like IP address and community string and doing an SNMP test connection it returns a failure message. SNMP configuration on ISE is quit simple. Only two commands are needed which are the SNMP server IP and community string values. Searching on the web, i saw a bug CSCun42967 that documents SNMP problems with ISE 1.2. Could that be the problem? or if there is any limitations for this integration?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...