Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Snmp nac (Clean access) and ISE on same switch

Hi

Is it possible to run ISE ( radius nac) and Clean Access ( snmp nac) on the same switch ?

I meen that configuration Will coexist on switch in A migration face.

Is it doable and how ?

Regards Henrik

3 REPLIES

Re:Snmp nac (Clean access) and ISE on same switch

Hi this should be possible since these are port based controls. Just enable the dot1x on the port and then uncontrol the port from the cam.


Sent from Cisco Technical Support Android App

Tarik Admani *Please rate helpful posts*
Community Member

Snmp nac (Clean access) and ISE on same switch

Hi Tarik

Thanks for your reply, i will try.

Renards Henrik

Snmp nac (Clean access) and ISE on same switch

Hello, yes you can have both SNMP for NAC and RADIUS for ISE in the same global configuration of the switch. But please remember there's also the switchport configuration. Each switchport must be controlled either by ISE or by NAC, only by one of them.

So you can have for example g1/0/1 authorized by ISE and g1/0/2 authorized by NAC and so on.

Please rate if this helps

201
Views
0
Helpful
3
Replies
CreatePlease to create content