Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

snmp stops working on ISE 1.1.2(145) patch 10

I have a Primary Admin/Primary Monitoring, Secondary Admin/Monitoring and two PSN nodes, distributed mode

A few days ago, the primary Admin/Monitoring node snmpd daemon just stopped working.  I had to remove the snmp community string and re-add it back and snmpd starts working again.

Yesterday, the secondary admin/monitoring node snmpd daemon also stopped working and had to do the same thing (remove and re-add snmp community string) for snmp to work again.

Is this a bug in ISE?

1 REPLY

snmp stops working on ISE 1.1.2(145) patch 10

There looks like there was a bug fixed for this issue in 1.1.1, you may need to open a tac case and see if the bug has resurfaced.

http://www.cisco.com/en/US/docs/security/ise/1.1.1/release_notes/ise111_rn.html#wp411891

CSCub89895

SNMP process stops randomly due to an issue in netsnmp

The netsnmp daemon on Cisco ISE can halt, causing any SNMP monitoring of  the Cisco ISE node to fail until the daemon is restarted. This issue  has been observed in Cisco ISE, Release 1.1.1.

Workaround   Remove all SNMP commands and re-add them to start the daemon again or restart the ISE node.

For more information, see: http://sourceforge.net/tracker/index.php?func=detail&aid=3400106&group_id=12694&atid=112694

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
383
Views
0
Helpful
1
Replies
CreatePlease to create content