Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

specify pool name in radius reply

hello all . I have 2 pools of IPs on the router ans have dialup vdpn sessions on it , I need some specific users get from a pool and other users from the other pool. Can I return the pool name in the radius reply when the user is authenticating ? and how ?

2 REPLIES
Silver

Re: specify pool name in radius reply

I guess this sould be possible using the "vendor-specific" attributes in RADIUS on Cisco ACS. Can anyone show the steps to configure this?

Silver

Re: specify pool name in radius reply

If you look in the group/user setup page of ACS you'll see a section "IP Assignment"

For each group of users, just select the "Assigned from AAA Client pool" and enter the pool name.

When users authenticate, ACS will send the pool name back to the device.

This is protocol independant and to some extent RADIUS vendor independant too in that it knows about IETF, Cisco and Ascend assignment methods.

286
Views
0
Helpful
2
Replies
CreatePlease login to create content