01-17-2014 02:08 PM - edited 03-10-2019 09:17 PM
Hello,
I just upgraded to ISE 1.2 and lost access to my two repositories. This was expected.
I was able to get one of my repositories back by deleting and recreating it. I created it in the GUI and then ran the command "crypto host_key add "IP address of repo server".
When I deleted and recreated the second repo but still can't run a backup to it. I tried running the CLI command "Show Repo Backup" and I get a response " % SSH connect error". I have run the "crypto host_key add" command for this repo, also.
I searched the Cisco Forum and even Googled it with minimal results.
Any ideas?
01-18-2014 11:07 AM
What type of repository are you using? Solarwinds?
11-25-2015 06:47 AM
Hi,
i have the same error.
does there exists any solution to this problem?
regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: