Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

% SSH connect error when "show repo xxxx" in Cisco ISE

Hello,

I just upgraded to ISE 1.2 and lost access to my two repositories. This was expected.

I was able to get one of my repositories back by deleting and recreating it. I created it in the GUI and then ran the command "crypto host_key add "IP address of repo server".

When I deleted and recreated the second repo but still can't run a backup to it. I tried running the CLI command "Show Repo Backup" and I get a response " % SSH connect error". I have run the "crypto host_key add" command for this repo, also.

I searched the Cisco Forum and even Googled it with minimal results.

Any ideas?

2 REPLIES
Cisco Employee

% SSH connect error when "show repo xxxx" in Cisco ISE

What type of repository are you using? Solarwinds?

New Member

Hi,

Hi,

i have the same error.

does there exists any solution to this problem?

regards

791
Views
0
Helpful
2
Replies
CreatePlease login to create content