I have an access point configured to use dot1x (MS-PEAP) which authenticates against ACS. Everything work fine, but there are some strange logs appearing in failed attempts. I think it is some sort of misinterpretation in ACS.
My ACS is 4.1
My access point is AIR-AP1231G version 12.3
I also have attached the logs. Hope anyone can help me clarify this.
This document provides a sample configuration for LEAP or MAC authentication.
Note: This guide assumes the most basic configuration. It does not cover configuration of more advanced encryption modes such as Cisco Key Integrity Protocol (CKIP) and Cisco Centralized Key Management (CCKM).
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...