Hi,
I was configuring ACS SE from the console but got stucked in between. Referred the installation guide for the same. After doing the basic configuration when the ACS SE rebooted i was not able to get the login prompt on my console. The ouput which i m getting is pasted below:
Press <SpaceBar> to update BIOS.
[2;37;40mAMIBIOS(C)2006 American Megatrends, Inc.
[06;00H BIOS Date: 11/26/07 15:02:44 Ver: 08.00.14
[07;00H CPU : Intel(R) Pentium(R) 4 CPU 3.40GHz
[08;00H Speed : 3.40 GHz [09;00H
[10;00H Press F2 to run Setup
[11;00H Press F12 for BBS POPUP
[12;00H DDR2 Frequency:667 MHz, ECC Support in Dual-Channel Interleaved Mode
[13;00H Initializing USB Controllers .. Done.
[14;00H 1024MB OK [15;00H
[16;00H Auto-Detecting Pri Master..IDE Hard Disk
[17;00H Auto-Detecting Sec Master..ATAPI CDROM
[18;00H Auto-Detecting Sec Slave...
[19;00H [20;00H [21;00H -[22;00H [23;00H
[18;00H Auto-Detecting Sec Slave...Not Detected
[19;00H Pri Master : Hitachi HDS721680PLA380 P21OABEA
[2;37;40mAuto-detecting USB Mass Storage Devices ..
[23;00H BMC Responding
[06;00H Press F2 to run Setup
-[07;00H Press F12 for BBS POPUP
It gets hanged after this tried many things but no success.
Also one thing which i got to see during installations, there was an option to enable the GUI which i coudnt find in the installation guide. That options was given in installation guide after the device reboots. I had done the configuration for the same during that time as it stated over ther all the services will be enabled if i do enable it. I even tried it accessing through http://ip add : 2002 on the ethernet ports but no success.
Can anyone guide me on the same. Thanks in advance.
