Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

tacacs+ 3550 switch

I am tring to run an auto exec command when I login directly to the console I want to be authorized directly to the enable mode. Authorization to the telnet directly to the enable mode works fine from telnet just not from the console. Below is my relevent config. Thanks in advance.

aaa authentication login default group Networking enable

aaa authentication login console group Networking enable

aaa authorization exec default group Networking if-authenticated

aaa authorization exec console group Networking if-authenticated

aaa accounting exec default start-stop group Networking

aaa accounting exec console start-stop group Networking

line con 0

authorization exec console

login authentication console

transport input none

stopbits 1

1 REPLY
Silver

Re: tacacs+ 3550 switch

the configuration seems to be correct . For more information regarding the configuration kindly follow he url ,

http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a00801cdf4c.html#1020726

161
Views
0
Helpful
1
Replies
CreatePlease to create content