I have a C6509 with sup32 IOS based switch. I equally have tacacs authentication enables on the switch. But each time I telnet to the switch is brings the following:
Username: XXXXXXXX
Password: XXXXXXXX
Prompt>enable
User Access Verification
Username: XXXXXXXX
Password: XXXXXXXX
I do NOT like to have the second username. I expect after the enable command, I should just have be asked to key in my password and not asking me for a username again.
Here is the version of IOS of the switch:
s3223-adventerprisek9_wan-mz.122-33.SXH3a.bin
Here is the aaa config:
aaa new-model
aaa authentication login default group tacacs+ line enable
aaa authentication enable default group tacacs+ enable
aaa authorization exec default group tacacs+ if-authenticated
aaa authorization commands 15 default group tacacs+ if-authenticated
aaa accounting exec default start-stop group tacacs+
aaa accounting commands 15 default start-stop group tacacs+
regards,
Enrico
