Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TACACS source interface

I'm trying to force my router to use loopback0 or 1 interface to authenticate to TACACS server and I enter the command

ip tacacs source-interface loopback0 and it still used one of the vlan in the router and strange this when I do show run I don't even see this command configured on the router, is there someting I'm missing. It is Cisco6509 with MSFC and IOS code 12.1(22)E2.

Thanks.

1 REPLY
Silver

Re: TACACS source interface

Well, the only thing I can think of is you might be hitting a bug. There is definitely a loopback0 interface configured on your router? I use that command exactly as you have it without issue, and it always shows up in the config.

In ACS in reports->failed authentication logs does it show up with an "unknown nas" error with the vlan IP?

-Eric

331
Views
0
Helpful
1
Replies
CreatePlease to create content