I have attempted to configure our 800 series router to accept client to router vpns into our network. However the clients just dont connect, no error message either. I am a little lost what to do, any help would be Massively appreciate as ive already tried experts exchange and they cant see anything wrong with it. I have attached the config to this message.
i feel you have posted the main hub site config where your remote locations dials in and establish the ipsec tunnel.
But in your case the hub ip is not static you are getting the ip address from SP in this case how your remote clients will negotiate the isakmp and ipsec policies when they dont have a static peer ip configured in their configuration ?
untill unless you have a static ip configuredi n ur hub site i dont think its possible at all for your remote peers to negotiate the key thigns to establish the ipsec connectivity.
If u know the ip address and if you can manage the strain in setting or changin the peer ip everytime in the remote peer u can try that out but i havent tried something out like this yet and as u said if u have static ip in the live network setup it shuld work properly in that router .
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...