I am not sure what I am trying to do is possible, so I thought I would pose the question on here. In ACS 5.3, I would like to use an RSA server and AD to authenticate my network devices. So when I log into a router or switch I would enter my AD username, be prompted for my RSA token, then when I enable be prompted for my AD password, or visa versa. Can anyone tell if this is possible and how to write an access policy to achive this?
This is not possible since the ACS is built to send a pass for authentications that succeed on the identity store that is tied to your access policy, and if you enable identity store sequences you can either choose AD, RSA or internal, depending on your settings the requests can either cycle through a specific order and there are the other configurable options but not what you are looking for.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...