I have installed 2 ACS 5.2 appliances, the two appear as Primary. When I try to register one of them with the other one using "System Administrator -> Local Operation -> Deployment Operations" I get the following message:
This System Failure occurred: Unable to authenticate with node.. Your changes have not been saved.Click OK to return to the list page.
I have tried with both "ACSAdmin" and "admin" users with their respective passwords.
Am I doing anything wrong?
Is there any LOG I can check to troubleshoot this?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...