Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade from ACS3.3.2 to 3.3.4

I have a pair of 3.3.2 windows servers that need to be upgraded to 3.3.4. Is there any issues that I should know about before I do this upgrade. I assume I should do the backup servers first.

Thanks in advance.

Mike

5 REPLIES
New Member

Re: Upgrade from ACS3.3.2 to 3.3.4

Hi mike,

You need to take backup of your ACS 3.3.2 first.

The following link is the release note for ACS 3.3.4. ACS 3.3.2 can be directly upgraded to ACS 3.3.4.

Please have a look into the release note for any open issues.

http://www.cisco.com/en/US/products/sw/secursw/ps2086/prod_release_note09186a008079fc44.html#wp49712

New Member

Re: Upgrade from ACS3.3.2 to 3.3.4

Thanks I have seen the document. When you say do a backup is there a backup out of the ACS software, or do you just mean a full backup of the server?

Thanks

Mike

Cisco Employee

Re: Upgrade from ACS3.3.2 to 3.3.4

Hi,

Backup with ACS means the database backup which can be taken from System Configuration->ACS Backup.

Regards,

Vivek

New Member

Re: Upgrade from ACS3.3.2 to 3.3.4

Great that is what I thought you meant. I will do that. I just wanted to see if there were any other issues that people have run across. So all my setting "should" be there when I am done if I select "Import Existing Conf". I just want to make sure this goes somewhat smooth.

Thanks,

Mike

Cisco Employee

Re: Upgrade from ACS3.3.2 to 3.3.4

Mike,

That is right. All settings should be there if you select "Import Exisiting conf." while upgrading.

Regards,

Vivek

142
Views
0
Helpful
5
Replies
CreatePlease login to create content