When I try to upgrade ACS 3.1.1 to 3.2.1, the installation went fine until the homepage refuse to appear (i.e. http://127.0.0.1:2002). However, a fresh new ACS 3.2 installation (ie. no upgrade) will have no problem.
SP3 is required for acs 3.2.1, so you may want to upgrade sp3 after upgrading. How did you perform the upgrade? Just running setup.exe on acs 3.1.1? If thats the case, pl. uninstall ACS 3.1.1 and don't remove the database during the uninstall, then reboot the server, and finally install the ACS 3.2.1 and when it asked if you want to use the database the insatllation detected from your earlier version, please answer Yes. This may ressolve the issue, provided you have all the hw/sw requirement.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...