User exec shell Authorization on ASA using IAS radius
Using ASA 5540- 8.0(4)& trying to get the EXEC Shell (15)authorization for authenticated user fron IAS radius server. Have used the aaa authorization command on the ASA & have specified the attributes on the IAS radius as shown in the config guide but still the user is dropped into default exec level. I need to use the enable command to get the user to privilage exec level,
Re: User exec shell Authorization on ASA using IAS radius
Hi, I am using microsoft radius server to authenticate the users. I would like to get the exec shell level 15 authorization from the radius as well.
As per the config giude i need to add the aaa authorization command ont ASA. I then need to configur the radius attributes as shown in the config guide. This ii have done but it still dose not work. The config guide says i can the the exec shell 15 authorization from the radius. Is it possible for you to confirm this or this not possible & my interpritation of the config guide is not correct.
I am going to some investigation on the box this week end. So any help would be appriciated
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...