I have been trying to configure telnet access authentication and authorization using Radius (Cisco IOS/PIX) via CSACS. My ACS is a 90-day trial evaluation only, though I believe It has full featues capability. Every time I telnet to my switch, i get the following error:
User Access Verification
% Authorization failed.
Connection to host lost.
However, If I change my Radius settings to Radius (IETF), the whole thing works like magic. I do not want to use IETF, but I cannot make Cisco IOS/PIX work.
Can somebody help me in this? I can provide some more outputs for the asking.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...