Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG202XM as dot1x supplicant

Hello Community,

i have some troubles about my VG202XM as dot1x supplicant. I have found some informations to configure a normal router as a dot1x supplicant. But this commands are not work.

The tested way was:

en

conf t

dot1x credentials test

username test1

password test2

exit

interface fa 0/1

dot1x pae supplicant

Command rejected: Dot1x is not supported.

Dot1x is supported only on Ethernet interfaces configured in Access, Routed or Private-vlan Host Mode.

I can not type "switchport mode access" because it is a router not a layer 3 switch. I had add on this interface a ip address but there was the some message. I have no idea ....

ip routing <- is set

I hope anybody can help me.

1 REPLY
New Member

Hi Markus, they were opened a

Hi Markus,

 

they were opened a TAC-Case with an Defect-id.

#CSCus38551

 

best regards 

Andi

262
Views
0
Helpful
1
Replies
CreatePlease login to create content