Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Way to do Active/Backup (config replication) in ACS 4.1

Hi,

I had been trying to find out a way through which i can make on of my acs active & the second one as secondary ie the way in which i can replicate the config done on active one to the back up acs. I m using ACS SE 4.1

Thanks in advance for your suggestions.

--- Piyush

2 ACCEPTED SOLUTIONS

Accepted Solutions
New Member

Re: Way to do Active/Backup (config replication) in ACS 4.1

Hi,

You can use the RDBMS sychronization area to sync the 2 ACS boxes but I don't think there is a way to make one active and the other secondary on the ACS itself.

If you are authenticating users from your switches of wireless etc... You can make the "active" ACS listed first and the "secondary" ACS listed second. This way the secondary ACS would only be used it the active was unavailable.

HTH

Craig

Re: Way to do Active/Backup (config replication) in ACS 4.1

Hi Piyush,

Here is the link to set up replication,

http://cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080742f60.shtml

Regards,

~JG

Do rate helpful posts

3 REPLIES
New Member

Re: Way to do Active/Backup (config replication) in ACS 4.1

Hi,

You can use the RDBMS sychronization area to sync the 2 ACS boxes but I don't think there is a way to make one active and the other secondary on the ACS itself.

If you are authenticating users from your switches of wireless etc... You can make the "active" ACS listed first and the "secondary" ACS listed second. This way the secondary ACS would only be used it the active was unavailable.

HTH

Craig

Re: Way to do Active/Backup (config replication) in ACS 4.1

Hi Piyush,

Here is the link to set up replication,

http://cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080742f60.shtml

Regards,

~JG

Do rate helpful posts

New Member

Re: Way to do Active/Backup (config replication) in ACS 4.1

thanks 2 both of u man..

--- piyush

131
Views
0
Helpful
3
Replies
CreatePlease to create content