Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Windows Domain is not detecting in the ACS SE 4.0 for domain authentication

Hi,

We have ACS 4.0 SE, we are integrated domain authentication for the AAA auhtentication. For that we are installed primary and remote agents in member server but if we stops remote agent services in one of the server we are not seeing in any domains in the mapping of ACS and AD group. Please help me to over come this issue.

Thanks in advance

Regards,

Ram

1 REPLY
Silver

Re: Windows Domain is not detecting in the ACS SE 4.0 for domain

ACS Remote Agent supports only ACS SE. It cannot support ACS for Windows.While a single ACS Remote Agent can provide services to many ACS SE appliances, support is limited to five concurrent connections by the appliances served. For example, if you have three primary ACS appliances, and three secondary ACS appliances that are used for failover purposes only, the remote agent can provide services to all six appliances and stay below the maximum of five concurrent connections. Refer URL

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_configuration_guide_chapter09186a00805a1647.html

116
Views
0
Helpful
1
Replies