Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

11150 Switch stops transmitting at random

I have consistent problems with our 11150 switches, one will stop transmitting like it is the "backup" switch but it never transitions from being "master" so all traffic is stopped. It never shows a link failure or a state transition. There are no errors or drops on any of the next hop switches. We have replaced the hardware and still have the problem. Here is the error in the debug log:

MAR 3 22:52:27 5/1 425 FLOWMGR-7: Resetting port 2c01f00 ending at 114641

MAR 3 22:55:12 5/1 426 IPV4-7: Ipv4SfmForwRx: Ingress circuit non-exist

3 REPLIES
Cisco Employee

Re: 11150 Switch stops transmitting at random

what is the current software version ?

Could you capture a 'flow stat' from debug mode and send it to us.

Thanks,

Gilles.

New Member

Re: 11150 Switch stops transmitting at random

The software version is 5.00 build 69

Here is the output:

flow stat

Flow Manager Statistics:

Cur High Avg

UDP Flows per second 0 0 0

TCP Flows per second 0 6 0

Total Flows per second 0 6 0

Hits per second 0 0 0

Number of Allocated Flows (non-purged) 0

Number of Free Flows 262144

Number of Flow Drops 0

Max Number of Flow Control Blocks 615757

Number of Flows with SynAckPending 0

Accumulated Port Flow Statistics:

Current Number of Active Flows 0

Total Flow Accounting Reports received 10

Total Out of Sequence Packet Received 0

Total Spoof Queue Mis-Hits 0

-------------------------------------------------------------------------------

Port CE Active Total Acct TCP UDP Rst FCBs

-------------------------------------------------------------------------------

#e1 1f00 0 0 0 0 0 0 15216

#e12 2c01f00 0 0 0 0 0 0 15216

#e13 3001f00 0 0 0 0 0 0 31600

#e14 3001f01 0 10 10 0 0 0 126440

Bronze

Re: 11150 Switch stops transmitting at random

Please standby on this as I see you have a TAC case open. We are investigating this with regards to EPIF resets on the CSS. The engineer you are working with was instructed to get a "flow statistics" in debug mode.

Thanks

Pete Knoops

Cisco Systems

143
Views
0
Helpful
3
Replies
CreatePlease login to create content