05-14-2007 05:00 AM
Hello,
I'm new to using the 3750 switches and am trying to understand all of the necessary steps to completely remove a member from the stack. The current stack only consists of two switches and I need to remove one (which happens to be the slave)... leaving the other to run solo permanently.
From what I understand, the steps would go like this...
1.) Remove power from switch to be removed
2.) Issue command "no switch 2 provision ws-c3750-48p"
3.) Issue command "copy run start"
Done.
I would expect this to enable me to remove the switch and also removes all reference to the removed switch from the config.
Did I miss anything here?
Thanks!
-Adam
Solved! Go to Solution.
05-21-2007 10:34 AM
You may do a "no switch
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225see/scg/swstack.htm#wp1178943
05-21-2007 10:34 AM
You may do a "no switch
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225see/scg/swstack.htm#wp1178943
05-21-2007 11:03 AM
Phillip,
Thanks for the reply.
I've seen the link you provided before... I just wanted to make sure I wasn't missing anything... seemed a little to simple, but I guess that's all there is!
Regards,
-Adam
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide