Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

about backup CSS status check fot box-to-box redundancy

I want to use ping to check the backup CSS's status, I can ping the master's heartbeat interface's IP address,but can't ping the other end's.

I was try to use ACL,but its not work.So, how can I do it.

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: about backup CSS status check fot box-to-box redundancy

you can't.

The reason is that in box-to-box redundancy, the backup is in a waiting mode.

If you are using another type of redundancy, this should work.

Finally, in boxo-to-box redundancy you should not need to monitor the backup since they share the same config.

If the master fails, the backup will take over and use the same ip addresses.

So, your monitoring device does not need to monitor the backup.

Gilles.

1 REPLY
Cisco Employee

Re: about backup CSS status check fot box-to-box redundancy

you can't.

The reason is that in box-to-box redundancy, the backup is in a waiting mode.

If you are using another type of redundancy, this should work.

Finally, in boxo-to-box redundancy you should not need to monitor the backup since they share the same config.

If the master fails, the backup will take over and use the same ip addresses.

So, your monitoring device does not need to monitor the backup.

Gilles.

138
Views
0
Helpful
1
Replies
CreatePlease login to create content