I configured my Cisco ACE appliance for IAS Radius authentication. The authentication is not sucessful. I tried different attribute settings on the IAS server, but still the authentication fails.The configuration details on ACE appliance is as below,
From the last screenshot you have in your document, the Microsoft server is stating the reason for the failure as:
Authentication was not successful because an unknown user name or incorrect password was used
You might want to get a capture of the authentication process and verify that the username being sent to the RADIUS server is exactly what is configured on the RADIUS server. Also, double-check the password used. Your configuration on the ACE looks Okay, so I would focus for now on the user name and password.
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...
Introduction This document will run you through a step by step
configuration example of Inter VRF route leaking in Cisco Application
Centric Infrastructure(ACI). This article describes the steps with
screen shots of example configuration and some verifica...