Re: ACE 4710: Config Allows all traffic except large HTTP downlo
I've seen a similar fault. I suppose a lower MSS was sent in the TCP SYN handshake packets (1300 or 1380?) and the packets exceeding that value were dropped by the ACE. This is the default behavior which can be switched to a less strict mode by either
In our case, a linux web server was whose replies wouldn't keep to the MSS limit.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...