Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACE 4710 config

Hi,

I'm new to ACE and trying to configure AAA for it.

ACE's 4 eth interfaces are not showing up when I do "sh ip int b". please advise why?

can we configure tacacs for ACE for whole user group instead of doing it per user?

3 REPLIES
Cisco Employee

Re: ACE 4710 config

Does it show interface for the Admin user ?

Does it show them if you do not have AAA configured ?

What version do you have ?

Gilles

New Member

Re: ACE 4710 config

===

Does it show interface for the Admin user ? - no it doesnt.

Does it show them if you do not have AAA configured ? - no it doesn't show, i dont' have aaa configured right now.

What version do you have ? - I'm using "c4710ace-mz.A3_2_0.bin"

===

what could be the issue? do we need to have license to get it show up in "sh ip int b"?

Cisco Employee

Re: ACE 4710 config

The command is accepted but it just does not display anything - right ?

In this case this is not a license problem or AAA issue.

Are you in a context ?

The physical interfaces are only visible in Admin context.

And if you did not assign any vlan to your context, you will not see anything with the interface commands.

Gilles.

294
Views
0
Helpful
3
Replies
CreatePlease to create content