Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACE 4710 VIP to rserver and back

I have a scenario that I don't think is correct.

I have the following devices configured on the ACE

VIP - 161.80.201.32

rserver1 - 161.80.201.63

rserver2 - 161.80.201.64

I input the VIP into my browser and the web site appears. I login into the application and then the rserver's IP address is in the browser address bar. Is there a way to have all communication go through the VIP instead of rserver to client? I have attached a running config.

Thanks for any assistance.

Jeff

1 REPLY
Cisco Employee

Re: ACE 4710 VIP to rserver and back

Hi Jeff,

If all the communications are going through the ACE, you should always see the VIP address in the address bar.

From what you described, it's possible that, at some point the application is redirecting the client to the real address of the server. If that happens, the address bar will change and display the address of the server.

I would recommend you to get a traffic capture on vlan 196 while establishing a test connection from a client, and once you have it, look for HTTP redirects inside the flow.

Daniel

250
Views
0
Helpful
1
Replies