I have two rservers (in this case they are firewalls) and they have to replicate active sessions to each other in case one of them is gone. But I am not able to configure both as a backup-rserver for each other. It says "Cannot assign backup rservers in cyclic order". Only one backup-rserver can be configured at the same time. I don't know why but there must be a way to do this.
serverfarm host FW_OUTSIDE_FARM
backup-rserver FW1 ### can't be done ###
### It says "Error: Cannot assign backup rservers in cyclic order" ###
In this configuration only one way fail over scenario works. In case that we shutdown the FW1 during the traffic passing through the FW1, Active sessions can be transferred to FW0 successfully. But vice versa, cause of the I haven't reassigned backup-rserver for the FW0, active sessions are not able to be transferred to FW0 back.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...