Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACE Configuration Synchronization failure

I have defined the FT group on ACE, but i don't see configuration getting update on the other module.

The response for 'sh ft peer detail' is as follows

Peer Id : 1

State : FSM_PEER_STATE_DOWN

Maintenance mode : MAINT_MODE_OFF

FT Vlan : 200

My IP Addr : 1.1.1.1

Peer IP Addr : 1.1.1.2

Query Vlan : Not Configured

Peer Query IP Addr : 0.0.0.0

Heartbeat Interval : 200

Heartbeat Count : 20

Tx Packets : 0

Tx Bytes : 0

Rx Packets : 0

Rx Bytes : 0

Rx Error Bytes : 0

Tx Keepalive Packets : 0

Rx Keepalive Packets : 0

TL_CLOSE count : 0

FT_VLAN_DOWN count : 0

PEER_DOWN count : 1

SRG Compatibility : INIT

License Compatibility : INIT

FT Groups : 1

Please assist.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Silver

Re: ACE Configuration Synchronization failure

Can you please paste you configuration.

Did you configure both modules with the FT configuration?

Is the FT vlan available on both chassis?

Is the FT vlan trunked between the two chassis?

3 REPLIES
Highlighted
Silver

Re: ACE Configuration Synchronization failure

Can you please paste you configuration.

Did you configure both modules with the FT configuration?

Is the FT vlan available on both chassis?

Is the FT vlan trunked between the two chassis?

New Member

Re: ACE Configuration Synchronization failure

Your first question was the answer. VLAN was missing on the second chassis.

Thanks.

Silver

Re: ACE Configuration Synchronization failure

you're welcome.

174
Views
0
Helpful
3
Replies
CreatePlease login to create content