Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACE - debug xlate

Is possible to debug nat transactions on the ACE. I know that the commands show xlate or show nat-fabric exist. But is possible to use some command which is similar like debug ip nat trans like on the Cisco router? Or is other method for real-time debug the ip nat translations on the ACE? Thank you very much. Roman

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ACE - debug xlate

There is no debug as the nating is done in a micro engine which has very limited functions.

You can however enable "logging fastpath" and send the log messages to a syslog server (mandatory) and you should get an entry for each connection coming in and the associated xlate.

Here is an example:

%ACE-6-302026: Built ICMP connection for faddr 4.20.98.115/39033 gaddr 199.87.8.250/8 laddr 10.129.200.145/0

Gilles.

1 REPLY
Cisco Employee

Re: ACE - debug xlate

There is no debug as the nating is done in a micro engine which has very limited functions.

You can however enable "logging fastpath" and send the log messages to a syslog server (mandatory) and you should get an entry for each connection coming in and the associated xlate.

Here is an example:

%ACE-6-302026: Built ICMP connection for faddr 4.20.98.115/39033 gaddr 199.87.8.250/8 laddr 10.129.200.145/0

Gilles.

709
Views
0
Helpful
1
Replies