Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Ace load balance port 8091

Hi,

I need to balance port https in port 8091, I already make this configuration in port 443 and works, but with port 8091 the sessions are broken and the users have to constantly make login

probe tcp KPalive_server_8091

  port 8091

  interval 10

  faildetect 2

  passdetect interval 10

  passdetect count 2

  open 1

rserver host server01

  ip address 192.168.32.128

  inservice

rserver host server02

  ip address 192.168.32.129

serverfarm host SRVfarm_server

  probe KPalive_server_8091

  rserver server01

    inservice

  rserver server02

    inservice

sticky layer4-payload server_HTTPS

  serverfarm SRVfarm_server

  response sticky

  layer4-payload offset 43 length 64 begin-pattern "(\x20|\x00\xST)"

class-map match-all CLA4_HTTPS

  2 match virtual-address 192.168.30.60 tcp eq 8091

policy-map type loadbalance generic first-match POL7_HTTPS

  class class-default

    sticky-serverfarm server_HTTPS

policy-map multi-match POL4_HTTPS

  class CLA4_HTTPS

    loadbalance vip inservice

    loadbalance policy POL7_HTTPS

    loadbalance vip icmp-reply active

thanks

Fred

A mensagem foi editada por: Frederico Fred

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Ace load balance port 8091

Hi Fred,

If i have understood you correctly you want that traffic coming to VIP at 443 should be sent back to the server on port 8091, then you should make a slight change in config.

serverfarm host SRVfarm_server

probe KPalive_server_8091

rserver server01 8091

inservice

rserver server02 8091

inservice

You should define the port at which ACE should send the traffic to server after taking a LB decision.

Let me know if that helps.

Regards,

Kanwal

1 REPLY
Cisco Employee

Ace load balance port 8091

Hi Fred,

If i have understood you correctly you want that traffic coming to VIP at 443 should be sent back to the server on port 8091, then you should make a slight change in config.

serverfarm host SRVfarm_server

probe KPalive_server_8091

rserver server01 8091

inservice

rserver server02 8091

inservice

You should define the port at which ACE should send the traffic to server after taking a LB decision.

Let me know if that helps.

Regards,

Kanwal

417
Views
0
Helpful
1
Replies
CreatePlease to create content