Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACE MIB Value for Fail over

Hi,

     May I know the MIB value ACE (Application Contril Engine )will be generating  while a fail over occurs. Is the value same for contetx fail over as well ??

Regards

Jithesh

1 REPLY
New Member

Re: ACE MIB Value for Fail over

Hi,

I think this is the error code your looking for;

727012

Error Message    %ACE-2-727012: HA: FT Group group ID changed state to NewState. Reason: 
reason str.

Table 2-2 NewState Values and Descriptions

NewState Value
Description

FSM_FT_STATE_INIT

The initial state. Visible only when the configuration for the FT group exists but it is not in service.

FSM_FT_STATE_ELECT

After you enter the inservice command when you are configuring an FT group, the ACE enters the ELECT state. The redundancy state machine negotiates with its peer context in the FT group to determine the redundancy role (active or standby)

FSM_FT_STATE_ACTIVE

The active member of the FT group.

FSM_FT_STATE_STANDBY_COLD

This state can be entered if:

FT VLAN is down but the peer device is still alive.

Configuration or application state synchronization failure have occurred.

FSM_FT_STATE_STANDBY_CONFIG

The standby context is waiting to receive configuration information. Upon entering this state, the active context will be notified to send a copy of the running configuration.

FSM_FT_STATE_STANDBY_BULK

The standby context is waiting to receive state information. Upon entering this state, the active context will be notified to send a copy of the current states information for all applications.

FSM_FT_STATE_STANDBY_HOT

The standby context is ready to become active in a failover situation.

.

Values returned for the reason str variable can be one of the following:

FSM_FT_EV_PEER_DOWN

FSM_FT_EV_PEER_FT_VLAN_DOWN

FSM_FT_EV_PEER_SOFT_RESET

FSM_FT_EV_STATE

FSM_FT_EV_TIMEOUT

FSM_FT_EV_CFG_SYNC_STATUS

FSM_FT_EV_BULK_SYNC_STATUS

FSM_FT_EV_COUP

FSM_FT_EV_RELINQUISH

FSM_FT_EV_TRACK_STATUS

FSM_FT_EV_UPDATE

FSM_FT_EV_ENABLE_INSERVICE

FSM_FT_EV_DISABLE_INSERVICE

FSM_FT_EV_SWITCHOVER

FSM_FT_EV_PEER_COMPATIBLE

FSM_FT_EV_MAINT_MODE_OFF

FSM_FT_EV_MAINT_MODE_PARTIAL

FSM_FT_EV_MAINT_MODE_FULL

Check from the above ID onwards for more details around ft status.

Cheers

Scott

644
Views
0
Helpful
1
Replies
CreatePlease to create content