ACE module hung and required hard reset !!Plz help
ACE module had bit flip and it was hunged after that.I was not able to run any command(i.e For ex if i run show ft status nothing was displayed).I was not able to run any command on the standby ACE as well is this could be both the ACE module ACTIVE?
Manuaaly reboot from the ACE did not work. I had to forced hardare reset from cat 6500.
Re: ACE module hung and required hard reset !!Plz help
Usually in the case of the bit flip the ace will reset itself, which clears the problem. In order to understand what is happining to your ACE, you would have to open a TAC case, and provide show tech information, as well as any files that were generated in the "core:" directory. You can view these using the command "dir core:"
It seems odd that the standby ACE also wouldn't respond to any command input. Did you have to reset it as well? If you had to reset it as well, then it may have encountered the same conditions that caused the hang on the primary.
Was there any syslog messages generated on the 6500 switch during the time?
Introduction This article will help you understand the steps on how to
download the UCS licenses from the Cisco Systems website and then
installing it on the UCS. The redacted (blue lines) just covers up
certain numbers for privacy please do not take them...
Introduction This article will help you understand and educate the
customer on how to clear their "expired licenses"
(license-graceperiod-expired) from their UCS-M. If a customer just
purchased a license and needs a step by step guide on how to download
Introduction Prepositioning is a powerful tools on the WAAS platform but
it is not always easy to figure out why your jobs are failing when
trying to retrieve the files.Here is a method that should help you to
figure out the reason why they are not succes...