Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACE Module Sync Issue

Team,

We recently had an issue that the active ACE module would not sync to the standby ACE module, the following commands fixed our issue:

On the active do :
no ft auto-sync startup-config
no ft auto-sync running-config

wait about a minute and enable with:

ft auto-sync startup-config
ft auto-sync running-config

Regards,

John...

  • Application Networking
7 REPLIES
Cisco Employee

Re: ACE Module Sync Issue

this is typical. If you get in a state where standby can't sync (say for example ssl certs and keys

or probe scripts were not copied to standby) then you correct the condition by copying the files

to standby ft will not re-initiate bulk config unless you execute those commands

. This is typical when trying to correct standby_cold condition.

New Member

Re: ACE Module Sync Issue

Does this have any affect on connectiosn on the ACE?  I want to run this command but I can nerver drop below 4,000 connections.  I am feerful it may  drop connections. NAy feedback would be appreciated!

Chris

New Member

Re: ACE Module Sync Issue

Chris,

I did not notice any dropped connections when I ran this command, I will admit that I did not have many connections to start with. I did not find any information on this by looking at the documentation: http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/ace/v3.00_A2/command/reference/config.html#wp1002392

John...

Cisco Employee

Re: ACE Module Sync Issue

the command will not cause dropped connections. Whaqt it does is kick off config sync nothing else.

This happens all on the control plane. Load balanced connections and through ace connections are on the data plane and

are not affected.

New Member

Re: ACE Module Sync Issue

Liltrenta,

Thank you, this is good information for the community.

Regards,

John...

New Member

Re: ACE Module Sync Issue

For the record, I ran this command on a box whith >4000 connections and nothing dropped.  Thanks for sharing your expierence.

Chris

New Member

Re: ACE Module Sync Issue

Your a brave person Chris, thanks for the info.

John...

755
Views
12
Helpful
7
Replies
This widget could not be displayed.