I am working on configuring a ACE module to load balance connections (Outlook clients, and OWA) to the Exchange CAS servers.
Does anybody have a working CLI configuration for all or part of this configuration using and ACE module or appliance that they would be willing to share? The only examples I can find are using ANM to configure the ACE, and I do not have access to ANM.
I didn't get any responses to my post. However, I did find a sample configuration for the ACE at the back of the "Cisco UCS and Application Delivery for Microsoft Hyper-V Virtualization of Exchange 2010 with NetApp Storage" document.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...