Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACE - Not able to configure Context

All,

I have configured an ACE with some contexts. I think I have configured it according to the documentation.

If I switch to a different context using the changeto command, I switch to the context, but get the following error message:

NOTE: Configuration mode has been disabled on all sessions.

Anyone has an idea how to solve this?

Thanks, Pieter-Jon Buitelaar

2 REPLIES
Cisco Employee

Re: ACE - Not able to configure Context

Pieter,

you can only change the config on the active ACE. So, verify if you are on the active unit with the 'sho ft group det' command.

Gilles.

New Member

Re: ACE - Not able to configure Context

Gilles,

I am running a single ACE in single mode not in FT mode.

However, after rebooting the ACE module, I was able to go into conf mode in all contexts.

Any explanation for this behavior?

Thanks for your reply, Pieter-Jon

2054
Views
0
Helpful
2
Replies