Hi, I have a requirement to use the ACE to provide Active/Standby service for 2 services located on 2 physical servers. Server A is active for one port and backup for antoher, Server B vice versa.
As well as this, I am doing port translation - incoming requests to one port are being translated to one of two ports - see config below
rserver host TEST-FE01
ip address 10.100.100.1
rserver host TEST-FE02
ip address 10.100.100.2
serverfarm host test-farm
rserver TEST-FE01 20902
backup-rserver TEST-FE02 20902
rserver TEST-FE01 20903
rserver TEST-FE02 20902
rserver TEST-FE02 20903
backup-rserver TEST-FE01 20903
My problem is that I want to configure probes for each ip/port combination, but I can't seem to achieve this as my server farm contains servers that listen on more than one port and a probe can only be configured with one TCP port and can only be applied to either the rserver or the whole serverfarm.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...