I need configure redundancy between two ACE modules (no problem). There is context in bridge mode. My question is, in which state is standby context. Is it in blocked state (that means, it not ansfer to any L2 requests) similar as for example ASA? I need explain loop-free topology.
No, you should configure your ACLs and service-policies on the VLAN interfaces, not the BVI.
You should follow the traffic flow:
It is send by the upstream router into a particular VLAN (client-side) towards the VIP address (which is located inside the client-side VLAN and is reachable via the VLAN interface on the ACE). That is where you need to put your ACLs and service-policies.
Same way for the return traffic, it enters the ACE via the VLAN interface.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...