I'm trying to configure a routing load-balance with Cisco ACE Module based on the following scenario:
local users has a router (R1) as it default gateway, this router (R1) has a default route to the VIP that represent the serverfarm with two linux servers that should be used for Data Shaping over the WAN. I need to balance the traffic over the two linux servers and not necessary over the WAN.
The problem is that when I set up the local network router default route to VIP the routing process simply stop work ! If I change the route to the real server ip address everything start working again without any problem.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...