In looking into my earlier problem with SSL termination I set up a simple test context to try to reproduce it. I now have a situation where either HTTP or HTTPS access works - but never both. Which protocol works depends on how many times I remove the service policy and re-apply it. Removing and readding causes the working protocol to flipflop between HTTP and HTTPS.
The numbers from a "sh cfgmgr internal table vip" don't entirely match.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...